- Use Chrome or Edge
- Plug your board into your computer
- Short the connection of the E-Stop connector
- Click the Connect button
- Select device on CP2102N USB to UART Controller. (This step requires drivers, presumably you already have them. Download)
- Select Install...
- In the Erase prompt just click Next
- In the next prompt click Install
- It should now start flashing, wait a couple minutes to finish
- Boot the board in Restore Mode to complete the flashing process
To enter Restore Mode power the device while pressing the User Button for more than 9 seconds, you will see both LEDs turn steady on, then release the button. To continue the restore process, press the button once, then, LED 2 will blink 4 times before applying the factory configuration, to stop this or exit this mode simply unplug the device. After the restore is done the device will restart.
NOTE: Make sure to close anything using your devices com port (e.g. Serial monitor)